ADS Technologies Wireless Cable Modem Gateway SBG1000 - Manual (Page 91)

85 SBG1000 User Guide
Home
X
Exit Print
Overview Installation Troubleshooting Contact FAQ Specifications Glossary License
Configuration: Basic Gateway TCP/IP Wireless Print Server USB
Configuring the Print Server
The SBG1000 print server supports a connected printer using Microsoft, UNIX (Linux), or Apple printing.
To configure the print server
1 Start the Setup Program as described in “ Starting the SBG1000 Setup Program ”.
2 On the left frame, click Printer to display the Printer CONFIGURATION > basic page:
3 (Optional) For a printer that supports bi-directional communication, you can enable Extended Capabilities
Port (ECP) Mode, which can provide a performance benefit over a standard port.
4 Use the following pages to configure the print server for the necessary platform(s):
5 Power off the SBG1000.
6 Connect the printer to the printer port on the SBG1000 rear panel.
7 Power on the printer.
8 Power on the SBG1000. If printer configuration was successful, the printer icon lights on the SBG1000 front
panel.
If the printer icon is not displayed, check the printer cable connection and power the printer and the SBG1000
off and on again. Verify that Enable printer is checked on the Printer CONFIGURATON > basic page.
9 Add the printer to each computer following one of:
•
Adding a Printer in Windows 98 or Windows Me
•
Adding a Printer in Windows 2000
•
Adding a Printer in Windows XP
For information about using the line printer (lpr) command to print a file, see “ Printing a File Using a Command ”.
Windows Printer > CONFIGURATION — Microsoft smb Page
Macintosh Printer > CONFIGURATION — Apple Page