AMX Modero NXD-1000Vi - Manual (Page 37)

Installation
27 10" Modero Widescreen Touch Panels
10. Place the Faceplate back onto the main NXD-1000Vi unit. Make sure to align the Microphone,
Light, and PIR Motion sensor locations on the main unit to their respective openings on the
Faceplate assembly.
Installing the Button Trim Ring
The outer No-Button Trim Ring is secured to the Faceplate with plastic latches. In order to re-install the
Button Trim Ring back onto an NXD panel which has had the default Button Trim Ring features
removed; you must first remove the No-Button Trim Ring:
1. To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until the
entire Faceplate comes away from the panel.
2. Turn the Faceplate over to expose the inside surface and view the Trim Ring latches.
3. In a single motion, press down and then outwards on the three Trim Ring latches located along the
top of the internal surface of the Faceplate to begin removing the Trim Ring. Removing the Internal
Faceplate from the panel exposes the pushbuttons openings left from an earlier removal of the
pushbuttons and light pipes.
4. Gently tug along the edges of the No-Button Trim Ring and work your way around the edges to
remove it from the Faceplate (FIG. 18).
5. From along the internal surface of the Faceplate, install the two buttons by firmly inserting them
into the button openings until the Button latch secures the button in place (FIG. 18).
6. Install the pair of clear light pipe strips by pushing light pipes over the two black light pipe latches.
7. Grasp the Button Trim Ring on both sides and fit it into the groove along the outside surface of the
Faceplate (made available by the removal of the previous Trim Ring).
8. Gently insert the Button Trim Ring latches into their corresponding openings on the outer surface of
the internal Faceplate (FIG. 19).
FIG. 18 Removing the No-Button Trim Ring
Button Trim Ring
Trim
(with button openings)
Faceplate
NXD-1000Vi Panel/enclosure
Ring
Latches
Button and Light Pipe removal
(showing the inside surface of Faceplate)
(outside surface shown)
Button latch
Light Pipe latch
(black)