AMX Modero NXD-1000Vi - Manual (Page 44)

Installation
34 10" Modero Widescreen Touch Panels
3. Remove the Faceplate/bezel (A in FIG. 25) from the main NXD unit (B in FIG. 25) by gripping the
faceplate and pulling with gentle outward force.
4. Thread the incoming power, RJ-45, Ethernet, USB, and any optional audio/video wiring (from their
terminal sources) through the surface opening. Leave enough slack in the wiring to accommodate
any re-positioning of the panel.
5. Connect all data and power wiring connectors to their corresponding locations along the left side of
the (un-powered) NXD touch panel.
Verify that the terminal end of the power cable is not connected to a power source before
plugging in the 2-pin power connector.
The USB connectors can be from a either a USB extension cable, or a wireless USB RF
transmitter.
6. Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify that the panel is receiving power and functioning properly before finalizing
the installation.
FIG. 24 NXD-1000Vi Wall Mount panel dimensions using #4-40 mounting screws