Sony VPL-VW100 - Manual (Page 30)

GB 30
Projecting the Picture on the Screen
2
Press the ? / 1 (on/standby) switch to turn on the projector.
The ON/STANDBY indicator flashes in green, and then lights in green.
3
Turn on the equipment connected to the projector.
Refer to the operating instructions of the connected equipment.
4
Press INPUT repeatedly to select the input you want to project
on the screen.
Display the indication of the input you want.
Example: To view the picture from the video equipment connected to the
VIDEO INPUT connector.
*Set the “Input-A Signal Sel.” setting and “DVI Signal Sel.” setting in the Setup
menu according to the signal input. When you set it to “Auto,” and cannot
display the picture properly, select an appropriate signal according to the input
signal. (
1 page 53)
Tip
When “Auto Input Search” is set to “On” in the Function
menu, the channel
of the input signal is automatically displayed when you press INPUT.
ON/
STANDBY
Flashes in green for a few
seconds, and then lights in
green.
Video
INPUT
To view the picture from Press INPUT to
display
Video equipment connected to the VIDEO INPUT
connector Video
Video equipment connected to S VIDEO INPUT connector S-Video
Component equipment connected to Y/C
B
/P
B
/C
R
/P
R
on the
projector
Component
RGB/component equipment connected to the INPUT A
connector Input-A*
Video equipment connected to the DVI-D connector DVI*
Equipment connected to the HDMI connector HDMI