Sony VPL-VW100 - Manual (Page 60)

GB 60
Troubleshooting
On-screen display
Remote control
The LAMP/COVER or TEMP/FAN indicator lights up or flashes if there is
any trouble with your projector.
The picture is not clear. c Adjust the focus. (1 pages 25 and 31)
c Condensation has accumulated on the lens. Leave the projector
for about two hours with the power on.
The fan is noisy. c Check the setting of “High Altitude Mode” in the Installation
menu. ( 1 page 52)
The picture flickers. c Adjust “Dot Phase” for “Adjust Signal” in the Signal menu
properly. ( 1 page 47)
Symptom Cause and Remedy
On-screen display does not
appear. c Set “Status” in the Setup menu to “On.” ( 1 page 53)
Symptom Cause and Remedy
The remote control does
not work. c Batteries could be weak. Replace them with new batteries. (1
page 12)
c Insert the batteries with the correct polarities. (1 page 12)
c If there is a fluorescent lamp near the remote control detector,
the projector may work improperly or inadvertently. Change the
setting of “IR Receiver” in the Installation
menu. ( 1 page
51)
Warning Indicators
TEMP/
FAN
LAMP/
COVER
POWER
SAVING ON/
STANDBY
LAMP/COVER indicator
TEMP/FAN indicator