Message lists, Warning messages – Sony VPL-VW100 User Manual
Page 61
61
GB
Troubleshooting
Ot
h
e
rs
Warning messages
Symptom
Cause and Remedy
LAMP/COVER flashes.
c Close the top cover and the lamp cover securely, or attach the
filter holder securely. (
LAMP/COVER lights up.
c The lamp has reached the end of its useful lifespan. Replace the
lamp. (
c The lamp has reached a high temperature. Wait until the lamp
cools, and then turn on the power again. (
TEMP/FAN flashes.
c The fan is broken. Consult with qualified Sony personnel.
TEMP/FAN lights up.
c The internal temperature is unusually high. Check to ensure that
if nothing is blocking the ventilation holes or whether or not the
projector is being used at high altitudes.
LAMP/COVER and
TEMP/FAN light up.
c Disconnect the AC power cord, re-connect it, then turn on the
power again. If the indicators still light up, the electrical system
has a problem. Consult with qualified Sony personnel.
Message Lists
Message
Cause and Remedy
High temp.! Lamp off in 1
min.
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes.
Frequency is out of range!
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector.
Please check Input-A
Signal Sel.
c Set “Input-A Signal Sel.” in the Setup
menu to
“Computer” when an RGB signal is input from a computer. (
Please check DVI Signal
Sel.
c Set “DVI Signal Sel.” in the Setup
menu to “Computer”
when an RGB signal is input from a computer. (
Note
Be sure to remove the DVI cable to disconnect the connection
between the projector and a digital tuner and so on, before setting
“DVI Signal Sel.”
Please replace the Lamp/
Filter.
Lamp/Filter life remains
less than 50H.
c The lifespan of the lamp and the air filter is running out. (50
hours is an approximate figure.)
Please replace the Lamp/
Filter.
Lamp/Filter life remains
less than 15H.
c The lifespan of the lamp and the air filter is running out. (15
hours is an approximate figure.)