ARM IM-AD1 - Manual (Page 24)

Getting Started
2-4 Copyright © 2001-2003. All rights reserved. ARM DUI 0163B
2.3 Running the test software
The supplied test program tests each of the interfaces on the IM-AD1. The example
logic module configuration must be programmed into the logic module before the test
program can be run.
Note
The test software requires various cables to be connected to the IM-AD1, details of
these are given in the
readme.txt file on the IM-AD1 CD.
To run the test program:
1. Connect a Multi-ICE unit to the core module.
2. Power up the Integrator system.
3. Start the Multi-ICE server and autoconfigure it.
4. Browse to:
Install_directory\IM-AD1\example\software\selftest\build\ads1.1\selftest_Data\Release
5. Double-click the selftest.axf file. This starts the ARM debugger and loads the
test program.
6. Check the debugger is configured to use Multi-ICE by selecting Options
→
Configure Target. If Multi-ICE is not highlighted, select it and click OK .
7. Click Yes at the Reload last image prompt.
8. Press the Go button on the debugger to run the test software.
Use the menu in the debugger console window to test individual interfaces or to run all
the tests on all interfaces.