Alliance Laundry Systems UW POCKET HARDMOUNT UW35B2 User Manual
Page 35
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
33
F232085
Connecting External Liquid Supplies to
the Washer-Extractor
1. Remove plugs from base. Refer to Figure 15.
Plugs are assembled inside the tubing ring.
2. Install strain reliefs, included in the seal nut.
3. Insert tubes through base. Do not remove cups.
Tube should extend into the plastic cup, with the
exception of the softener tube, which should be
routed to the outside of the cup.
4. Tighten the seal nut to prevent tubing from
escaping the assembly.
The UW 2 speed washer-extractor has a polypropylene
supply dispenser with five supply compartments.
Refer to Figure 17.
Do not attempt to make chemical injection electrical
connections to points other than those provided
specifically for that purpose by the factory.
Chemical Injection Supply System
Number of dry supply compartments
5
Number of liquid supply connections
5
Liquid supply connection size,
in. (mm)
5/8 (15.9)