Using an external power source, Using your camera abroad – Sony DSC-P2 User Manual
Page 13
filename[C:\My Documents\_upload job\3075509111\3075509111DSCP2UC\02GB-DSCP2UC\04BAS.FM]
masterpage:L1-Right-01
model name1[DSC-P2]
[3-075-509-11(1)]
13
G
e
tt
in
g star
te
d
Using an external power source
,
Open the jack cover, and
connect the AC-LS1A AC
power adaptor (supplied) to the
DC IN jack of the camera.
Connect the plug with the v mark facing
up.
•
Connect the AC power adaptor to an easily
accessible wall outlet (wall socket) close by. If
something goes wrong while you are using the
adaptor, immediately shut off the power by
pulling the plug out of the wall outlet.
1
Jack cover
AC power adaptor
DC plug
,
Connect the power cord (mains
lead) to the AC power adaptor
and to a wall outlet (wall
socket).
•
When you have finished using the AC power
adaptor, disconnect it from the DC IN jack of
the camera.
•
The set is not disconnected from the AC power
source as long as it is connected to the wall
outlet (wall socket) even if the set itself has
been turned off.
2
2
To a wall outlet
(wall socket)
Power cord
(mains lead)
1
Using your camera
abroad
Power sources
You can use your camera in any country or
area with the supplied AC power adaptor
within 100 V to 240 V AC, 50/60 Hz. Use a
commercially available AC plug adaptor
[a]
, if necessary, depending on the design of
the wall outlet (wall socket)
[b]
.
•
Do not use an electrical transformer. Using this
may cause a malfunction.
AC-LS1A
01cov.book Page 13 Wednesday, April 3, 2002 11:17 AM