Sony VPL-VW12HT - Manual (Page 11)

11
(GB)
Location and Function of Controls
Adjuster buttons
How to use the adjusters
To adjust the height
Adjust the height of the projector as follows:
1
Lift the projector and press the adjuster buttons.
The adjusters will extend from the projector.
2
While pressing the buttons, adjust the height.
Then, release the buttons.
The adjusters will lock, then the height of the
projector will be fixed. For fine adjustment, turn
the adjusters to the right or left.
3
If necessary, turn the rear adjusters to the right or
left to adjust the height of the projector.
Notes
• Be careful not to let the projector down on your
fingers.
• Do not push hard on the top of the projector with the
adjusters out.
• If the adjusters are not extending from the projector
even though you have pressed the adjuster buttons,
loosen the adjusters by hand.
• If you move the projector with the adjusters
extended, the adjusters may be damaged. Move the
projector only after first retracting the adjusters.
How to use the supplied Cinema Filter
You can adjust the contrast by installing the supplied
Cinema Filter as follows.
1
Turn off the power and disconnect the power cord.
2
Align the screw of the filter with the thread around
the lens of the projector as illustrated below.
While holding the focus ring in place, turn the
filter clockwise.
Cinema Filter