Sony VPL-VW12HT - Manual (Page 31)

31
(GB)
The INSTALL SETTING
Menu
The INSTALL SETTING menu is used for changing
the install settings of the projector.
KEYSTONE MEM
ON: The DIGIT KEYSTONE setting is stored.
The data is retrieved when the projector power is
turned on. The setting will remain the same every
time.
OFF: The DIGIT KEYSTONE is reset to 0 when the
power is turned on next time.
DIGIT KEYSTONE
Corrects the trapezoidal distortion caused by the
projection angle.
If the base edge of the image is longer, set a negative
value; if the upper edge is longer, set a positive value
to display the image as a rectangle.
Note
Only if “ZOOM,” “FULL,” or “NORMAL” has been
selected in ASPECT of the INPUT SETTING menu,
you can change the trapezoidal dimensions.
The INSTALL SETTING Menu
INSTALL SETTING
KEYSTONE MEM: OFF
DIGIT KEYSTONE: 0
INSTALLATION: FLOOR-FRONT
CINEMA BLACK: ON
LAMP TIMER: 234h
INPUT-A
INSTALLATION
Set this item to reverse the picture horizontally or
vertically.
FLOOR-FRONT: The picture is not reversed.
CEILING-FRONT: The picture is reversed
horizontally and vertically.
FLOOR-REAR: The picture is reversed
horizontally.
CEILING-REAR: The picture is reversed
vertically.
Note
When using a mirror, be careful of how the
installation is carried out since the picture may be
reversed.
CINEMA BLACK
Switches the lamp wattage during projection.
OFF: Normal wattage.
ON: Enhances the black by reducing the lamp
wattage.
Notes
• It will take a few seconds for the projector to change
the lamp wattage during projection.
• If the CINEMA BLACK is set to ON, it starts with
OFF when the power is turned on, then changes to
ON after a while.
LAMP TIMER
Indicates how long the lamp has been turned on.
Note
This only displays the time. You cannot alter the
display.