Sony VPL-VW12HT - Manual (Page 15)

15
(GB)
Location and Function of Controls
Battery installation
1
Push and slide to open the lid, then install the two
R6 (size AA) batteries (supplied) with the correct
polarity.
2
Replace the lid.
Notes on batteries
• Make sure that the battery orientation is correct when
inserting batteries.
• Do not mix an old battery with a new one, or
different types of batteries.
• If you do not intend to use the Remote Commander
for a long time, remove the batteries to avoid damage
from battery leakage. If batteries have leaked,
remove them, wipe the battery compartment dry and
replace the batteries with new ones.
Notes on Remote Commander operation
• Make sure that there is nothing to obstruct the
infrared beam between the Remote Commander and
the remote control detector on the projector.
• The operation range is limited. The shorter the
distance between the Remote Commander and the
projector is, the wider the angle within which the
commander can control the projector.
• To turn on the key light when using as a wired
Remote Commander, install the batteries.
Note
If the Remote Commander causes a malfunction,
consult with qualified Sony personnel. We will
exchange the Remote Commander for a new one
according to the guarantee.
Be sure to
install the
battery from
the
# side.
Slide while
pressing down
on the lid.
4 VIDEO MEMORY keys
You can store an image setting to one of the VIDEO
MEMORY keys (1 – 6), and you can directly recall
the setting by pressing the appropriate key.
For more details on how to set the video memory, see the
VIDEO MEMORY of the INPUT SETTING menu on page
27 (GB).
5 MENU key
6 ENTER key
7 RESET key
8 Arrow ( M/m/</,) keys
9 MUTING PIC key
Cuts off the picture. Press again to restore the picture.
0 LIGHT switch
Pressing this switch turns on the key light on the
Remote Commander. Pressing this switch again turns
off the key light. If no keys are operated, the lights
will automatically turn off in 30 seconds.
Install the two batteries in the Remote Commander
when you use the key light.
qa Transmission indicator
Lights up when you press a key on the Remote
Commander.
qs CONTROL S OUT jack (stereo minijack)
Connects to the CONTROL S IN jack on the projector
with the connecting cable (not supplied) when using
the Remote Commander as a wired remote control. In
this case, you do not need to install batteries since the
power is supplied via the CONTROL S IN jack on the
projector.
If batteries are not installed, the Remote Commander
key light is not turned on.
qd Infrared transmitter