Sony VPL-VW12HT - Manual (Page 20)

20
(GB)
Projecting
To correct trapezoidal distortion
When the projected image is a trapezoid, change the
projector’s position/height by moving the adjusters.
For details on how to use the adjusters, see “How to use the
adjusters” on page 11 (GB).
If the image is still a trapezoid, correct it in DIGIT
KEYSTONE in the INSTALL SETTING menu.
When the base edge is longer than the upper
edge as shown in the figure below:
When the upper edge is longer than the base
edge as shown in the figure below:
Note
If “ZOOM,” “FULL,” or “NORMAL” have been
selected in ASPECT of the INPUT SETTING menu,
you can change the trapezoid. For details, see the
chart on page 26 (GB).
For details on signal types for which ASPECT can be
changed, see the chart on page 28 (GB).
For details on “DIGIT KEYSTONE,” see page 31 (GB).
Set the value to negative.
Set the value to positive.
4
Press the INPUT key to select the input source.
INPUT-A: Selects the video signal input from the
INPUT A connector, such as component
equipment.
INPUT-B: Selects the video signal input from the
INPUT B connector, such as component
equipment.
VIDEO: Selects the video signal input from the
VIDEO (VIDEO IN) jack.
S-VIDEO: Selects the video signal input from the
S VIDEO (VIDEO IN) jack.
5
Press the PATTERN key on the control panel to
display the test pattern, and turn the focus ring to
adjust the focus.
Press the PATTERN key again to clear the test
pattern.
6
Turn the zoom ring to adjust the size of the
picture.
Note
Looking into the lens when the projector is projecting
an image may cause injury to your eyes.
To cut off the picture
Press the MUTING PIC key on the Remote
Commander. To restore the picture, press the
MUTING PIC key again.
When projected images flicker
On rare occasions, projected images may flicker when
using the projector with CINEMA BLACK in the
INSTALL SETTING menu set to ON.
In this case, set CINEMA BLACK to OFF and clear
the menu display once. Then, display the INSTALL
SETTING menu again and set CINEMA BLACK to
ON.
For details on the INSTALL SETTING menu, see page 31
(GB).
On rare occasions, projected images may flicker until
the projector lamp fully warms up (this takes about 20
minutes after turning on the unit).
As this is not a sign of malfunction, continue to use
the projector normally.