Sony STR-DA5600ES - Manual (Page 111)

111 GB
Us
ing O
th
e
r
Fe
atures
3
Prepare the component for
playing.
For example, insert the video tape you
want to copy into the VCR.
4
Prepare the recording
component.
Insert a blank video tape, etc., into the
recording component (VIDEO 1) for
recording.
5
Start recording on the
recording component, then
start playback on the playback
component.
Notes
• Some sources contain copy guards to prevent
recording. In this case, you may not be able to
record from the sources.
• Analog input signals (audio and composite video)
are output from the analog output jacks.
• While only composite video signals are being
recorded, the auto standby function of the receiver
may start up and interrupt the recording. In this
case, set “Auto Standby” to “OFF” (page 134).
Switching the command
mode of the receiver and
the remote
You can switch the command mode
(COMMAND MODE AV 1 or COMMAND
MODE AV 2) of the receiver and the remote.
Switch the command mode from the initial
setting to the appropriate setting, if other Sony
component is operated accidentally by the
same remote, when you are operating the
receiver using the remote supplied with the
receiver.
The command modes of both the receiver and
the remote are those of the initial setting
(COMMAND MODE AV 2).
The receiver and the remote, on the contrary,
should use the same command mode. If the
command modes of the receiver and the
remote are different, you cannot use the
remote to operate the receiver.
1
Press ?/1 to turn off the
receiver.
2
While holding down 2CH/
A.DIRECT, press ?/1 to turn on
the receiver.
When the command mode is set to “AV2,”
“COMMAND MODE [AV2]” appears on
the display.
When the command mode is set to “AV1,”
“COMMAND MODE [AV1]” appears on
the display.
Switching the command mode of
the receiver
Switching the command mode of
the simple remote commander
2CH/A.DIRECT ?/1
DISPLAY
MUTING
continued