Sony STR-DA5600ES - Manual (Page 150)

150 GB
Setting remote control
codes that are not stored
in Quick Click
1
Select “ Settings” from the
menu, then press or b.
2
Select “Quick Click,” then press
or b.
3
Select “Source Component,” or
“Common Component,” then
press .
4
Select the component you
want, then press
.
5
Select “Learn Mode,” then
press .
6
Select the code number you
want to store as the new
command, then press
.
7
Keep pressing the
corresponding button on the
remote of the component to be
programmed while pointing the
remote toward the receiver’s
remote sensor until
“Complete” is displayed on the
TV screen.
“Test” is selected automatically after few
seconds when the registration of a new
code is completed.
8
Press .
The operation test of the programmed
code is started.
Proceed to step 9 if you will not perform
the operation test.
9
Select “Finish,” then press .
Note
The display window is turned off while the receiver
is registering the new code.
To use a command that has
been learned
1 Select “ Input” from the menu, then
press or b.
2 Select the component you want, then
press .
3 Press QUICK CLICK.
4 Select the button on the on-screen
remote used to learn that function, then
press .
V/v/B/b,
MENU
QUICK
CLICK
Remote sensor
About 5 cm - 10 cm (2" - 4")