Sony STR-DA5600ES - Manual (Page 50)

50 GB
7
Press to select “Next.”
“Save auto calibration (auto speaker
setup)?” appears. To save the
measurement results, follow the steps in
“Saving the measurement results”
(page 50).
If a warning message or error code
appears on the screen, see “Message list
after auto calibration measurement”
(page 52).
Note
When the speaker(s) is (are) out of the phase, “Out
Phase” is displayed on the TV screen. The “+” and
“–” terminals of the speaker may be connected the
other way around. However, depending on the
speakers, “Out Phase” appears on the TV screen
even though the speakers are connected properly.
This is because of the speakers’ specifications. In
this case, you can continue to use the receiver.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• You can change the unit of distance use in
“Distance Unit” in the Speaker settings menu.
To cancel the measurement
The measurement is cancelled when you
change the volume, switch functions, change
the setting of the SPEAKERS switch, or
connect headphones.
To save the measurement results obtained in
“Performing auto calibration” (page 48),
proceed with the following steps.
1
Press B/b to select “Yes” in
step 7 in “Performing auto
calibration” (page 48), then
press .
The selecting screen of the calibration
type appears.
2
Press V/v repeatedly to select
the calibration type, then press
.
The measurement results are saved.
Saving the measurement results
Parameter Explanation
Full Flat Makes the measurement of
frequency from each
speaker flat.
Engineer Sets the frequency to one
that matches that of the
Sony listening room
standard.
Front Reference Adjusts the characteristics
of all the speakers to match
the characteristics of the
front speaker.
User Reference Sets the frequency to one
that you adjusted using the
Setup Manager application
software. This parameter
appears only if you adjusted
the frequency using the
Setup Manager application
software (page 92).
OFF Sets the auto calibration EQ
to off.