Hdmi settings, Control for hdmi pass through h.a.t.s, Audio out – Sony STR-DA5600ES User Manual
Page 129
129
GB
Adju
stin
g Setti
ngs
HDMI settings
Makes the required settings for components
connected to the HDMI jacks.
Lets you turn the function which controls
components connected to the HDMI jack
using an HDMI cable on or off.
x OFF
x ON
Note
When “Control for HDMI” is set to “ON,” “Audio
Out” may be changed automatically.
Lets you output the HDMI signals to the TV
even when the receiver is in standby mode. For
details, see “Outputting the HDMI signals
even when the receiver is in standby mode
(Pass Through)” (page 105).
x OFF
x ON
Note
When “Control for HDMI” is set to “OFF,” you
cannot set “Pass Through.”
Lets you turn the H.A.T.S. (High quality
digital Audio Transmission System) function
on or off. When the H.A.T.S. function is turned
on, the sound quality is enhanced because
there is no jitter (timing gaps when reading
signals) when transmitting digital audio
signals.
x OFF
x ON
Notes
• It takes some time to output the sound after a
playback operation is performed on the connected
component (e.g., pressing the PLAY button,
pressing the STOP button, pressing the PAUSE
button) due to limitations of the H.A.T.S. system.
The time lag depends on the sound source. This
feature may be ineffective depending on the
component and the sound source, even if you set it
to ON.
• The components connected to the HDMI jack must
support the H.A.T.S. feature.
• When “Audio Out” is set to “TV+AMP,” the
H.A.T.S. function may not work depending on the
component connected or the status of that
component. In this case, select “AMP” for “Audio
Out.”
• The H.A.T.S. function of this receiver works when
a Sony SCD-XA5400ES is connected to the
receiver.
Stream information about the
H.A.T.S. function available
Lets you set the HDMI audio signals output
from the playback component connected to the
receiver via an HDMI connection.
x TV+AMP
The sound is output from the TV speaker and
the speakers connected to the receiver.
Control for HDMI
Pass Through
H.A.T.S.
Audio signal input Sampling frequency
Linear PCM 2ch
44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz
Linear PCM Multi
44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz
DSD
2.8224 MHz
Audio Out
continued