AMX MODERO VIEWPOINT WIDESCREEN TOUCH PANEL MVP-5200I - Manual (Page 13)

Introduction
5 MVP-5200i Modero Viewpoint Widescreen Touch Panel
Basic Operation
The MVP-5200i is operated using both its integral touchscreen and the navigation wheel on the right side
of the device. If the device has gone into its Standby Mode, a touch of the touchscreen or of the button
wheel will reactivate it.
The MVP-5200i device’s power use allows up to 96 continuous hours of use between rechargings of its
internal battery, but its battery charge lasts up to 120 hours if the device goes into Standby Mode during
that time. The device may be placed in its charging cradle at any time and operated within its cradle.
The device will automatically go into Sleep Mode after fifteen minutes of inactivity, and this limit may
be changed at any time. Any wireless Internet connection intended for the device will be reconnected
within approximately twenty seconds after the device is placed in its charging cradle. Depending upon
preselected settings, the device may be set to go into Active Mode as soon as it is placed in the cradle.
Navigation Wheel
The MVP-5200i device uses a unique button wheel for all commands not directly involving the
touchscreen. This wheel, known as a navigation wheel, is located in the upper right corner of the device
(FIG. 4). Used with the touchscreen, the navigation wheel allows scrolling and adjusting by turning the
wheel with a thumb or finger and then pressing down on one of the wheel’s compass points for up, down,
left, and right. The wheel is sensitive enough to adjust levels with one-third of a rotation. The center of
the navigation wheel also acts as a button in its own right: press down directly upon the wheel center for
the equivalent of an "Enter" keystroke
Press and hold the wheel center for three seconds to access the Setup pages (for more information, please
see the Setup Pages section on page 47). Continue to hold the wheel center for another three seconds to
access the Calibration page (page 84).
If the MVP-5200i needs to be shut down or reset for any reason, press and hold down the wheel center
button until the popup stating “panel shutting down” appears or the screen goes dark. To turn it back on,
press any of the wheel’s compass points and hold until the AMX splash screen appears on the
touchscreen.
The navigation wheel may also be programmed to initiate specific commands. For more information,
please see the Programming section on page 101.
Intercom Microphone
The MVP-5200i contains a built-in microphone above the upper lefthand corner of the touch screen for
video and audio conferencing capabilities. This microphone is concealed by the casing.
FIG. 4 Navigation wheel detail
Wheel center
Compass points
The navigation wheel may be turned
clockwise or counterclockwise
Shut down the panel by holding the wheel center button only if the Setup pages are
otherwise inaccessible. Regularly shutting down the device by this method can
corrupt the Flash memory.