AMX MODERO VIEWPOINT WIDESCREEN TOUCH PANEL MVP-5200I - Manual (Page 72)

Protected Setup Pages
64 MVP-5200i Modero Viewpoint Widescreen Touch Panel
Wireless Settings Page
Use the options on the Wireless Settings page (FIG. 61) to configure communication settings for the
wireless CF card (802.11b/g), and read the device number assigned to the panel.
Features on this page include:
FIG. 61 Wireless Settings page (reads from and assigns values to the WAP)
Wireless Settings Page
Back: Saves all changes and returns to the previous page.
Connection Status icon: The icon in the upper-right corner of each Protected Setup page provides a
constant visual indication of current connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
IP Settings: Sets the IP communication values for the panel:
DHCP/STATIC Sets the panel to either DHCP or Static communication modes.
• DHCP - a temporary IP Addresses is assigned to the panel by a DHCP
server. If DHCP is selected, the other IP Settings fields are disabled (see
below).
• Static IP is a permanent IP Address assigned to the panel. If Static IP is
selected, the other IP Settings fields are enabled (see below).
IP Address Enter the secondary IP address for this panel.
Subnet Mask Enter the subnetwork address for this panel.
Gateway Enter the gateway address for this panel.
Host Name Enter the host name for this panel.
Primary DNS Enter the address of the primary DNS server used by this panel for host name
lookups.
Secondary DNS Enter the secondary DNS address for this panel.
Domain Enter a unique name to the panel for DNS look-up.
MAC Address This unique address identifies the wireless Ethernet card in the panel (read-
only).
Active Roaming on
Channels 1&11 When enabled, connection allows active roaming between WAPs by switching
between channels 1 and 11 if the other channel is unavailable.