AMX MODERO VIEWPOINT WIDESCREEN TOUCH PANEL MVP-5200I - Manual (Page 14)

Introduction
6 MVP-5200i Modero Viewpoint Widescreen Touch Panel
Stylus
The MVP-5200i comes with a unique touchscreen stylus that slides into a storage groove on the right
side of the device when not in use. Replacement styluses may be ordered in a 3-pack (FG5966-30-xx)
from www.amx.com.
Kick Stand
Since the MVP-5200i device is designed to be a unit used away from its charging station, it has an
extendable "kickstand" on the back of the unit (FIG. 2). This may be opened by physically lifting the free
end of the kick stand away from the device. The device may then be propped up on a flat surface and
accessed in a normal fashion.
Audio/Video Capabilities
The MVP-5200i has the capability of displaying multiple JPEG and PNG files at one time. The device
also supports streaming motion JPEG video (of the sort used by many IP and Web cameras), as well as
MP3 and WAV audio files.
Power Management
The MVP-5200i utilizes a dual voltage external power supply. It may be recharged through the supplied
PS3.0 Power Supply (FG423-30), as well as through the MVP-TCS-52 Table Charging Station
(FG5966-1X) or the MVP-WCS-52 Wall Charging Station (FG5966-1X). For more information, see the
Accessories section on page 7 for details.
When not in active use, the MVP-5200i conserves battery life between chargings. In its Sleep Mode, the
device’s entire system is shut down, with only wakeup systems powered to detect incoming commands
or touch panel contact. Pressing any of the compass points on the navigation wheel will return the device
to its Active Mode,
For more information on the battery, see the Battery Life and Replacement section on page 153.
Cleaning the Touch Overlay, Case, and Navigation Wheel
You should clean the touch screen overlay after each day’s use to maintain the appearance of the device.
Always use a clean cotton cloth and a spray bottle containing water or a vinegar-based cleaner, as
alcohol-based cleaners can damage the device’s touch screen overlay. Do not directly spray the device:
instead, spray the cloth to clean the touch screen overlay and navigation wheel. Do NOT use an abrasive
of any type to clean the MVP-5200i, as this may permanently damage or remove the device’s finish.
Although the MVP-5200i unit is equipped with a mini-USB port, the device cannot be
powered through the USB port. The port is only used for uploading firmware.