AMX MODERO VIEWPOINT WIDESCREEN TOUCH PANEL MVP-5200I - Manual (Page 20)

Accessories
12 MVP-5200i Modero Viewpoint Widescreen Touch Panel
Installing the MVP-WCS-52
Since the Wall Charging Station is intended to be affixed to a wall or other permanent structure, care
must be taken to ensure its proper installation to prevent potential damage to the MVP-5200i placed
within.
Installing the Plastic Conduit Box
The plastic conduit box has two knockouts at the top of the box and four (4) lockdown wings attached to
the box with Phillips-head screws. For ease of installation, the interior of the box contains an "UP" arrow
pointing to the knockouts. The metal conduit box does not have to be installed beforehand, but it offers
an extra level of support.
To install the plastic conduit box:
1. Cut a hole into the wall or surface intended to hold the conduit box. The conduit box is sized 8.375
inches (21.27cm) long and 5.75 inches (14.60cm) high (FIG. 10), so the hole should be at least 1/4"
(0.64cm) smaller in each dimension.
2. Select the knockout to be removed from the top of the conduit box. The box has two knockouts, at
the top left and the top right.
Other than wall installation tools, the only tool required for this installation is a #1
Phillips screwdriver.
FIG. 10 Recommended cutout for plastic conduit box
8.38"
(21.27m
8.38"
(21.27cm)
6.09"
(15.4c)
6.09"
(15.46cm)
Make sure to measure the size of the intended hole before starting to cut it.