AMX MODERO VIEWPOINT WIDESCREEN TOUCH PANEL MVP-5200I - Manual (Page 70)

Protected Setup Pages
62 MVP-5200i Modero Viewpoint Widescreen Touch Panel
System Settings Page
The System Settings page (FIG. 60) displays sets the NetLinx Master’s communication settings.
The elements of this page include:
FIG. 60 System Settings page
System Settings Page Elements
Back: Saves all changes and returns to the previous page.
Connection Status icon: The icon in the upper-right corner of each Protected Setup page provides a
constant visual indication of current connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
IP Settings: Switches the IP settings between DHCP and Static. DHCP means that the IP
address and the subnet mask fields are greyed out; inStatic, press either of the
fields to open the IP Address and Subnet Mask keypads.
Master Connection: Sets the NetLinx Master communication values:
Type Sets the NetLinx Master to communicate with the panel via Ethernet, USB,
Mesh, or ICSNet. This is based on the cable connection from the rear.
• Ethernet is a CAT-5 cable (10/100Base T terminated in an RJ-45 connector)
used to network computers together and is used in most LAN (local area
networks). This description is also used to refer to both wired and wireless
communication. A Wireless Ethernet connection involves indirect
communication from the panel to a Master via a wireless connection to the
network.
• A USB connection is a direct connection from the panel’s mini-USB port to a
corresponding USB port on the PC (acting as a Virtual Master).