AMX MODERO VIEWPOINT WIDESCREEN TOUCH PANEL MVP-5200I - Manual (Page 16)

Accessories
8 MVP-5200i Modero Viewpoint Widescreen Touch Panel
4. Place the touch panel in the Charging Station cradle (FIG. 6), guiding it into place with the locking
grooves on each side of the cradle (FIG. 7). When fully seated, the touch panel’s charging station
connector should be in contact with the Charging Station’s charger pins.
Connections and Wiring
The PS3.0 is used to supply power to the MVP-5200i by routing incoming power through the connector
pins and charge the device’s internal battery
Recharging
To recharge the MVP-5200i, slide the device into the Table Charging Station cradle bottom-first and
make sure the device is fully seated in the Charging Station. The charger pins in the bottom of the cradle
(FIG. 7) must be in contact with the connector on the bottom of the MVP-5200i for it to start recharging.
The MVP panel will stop recharging automatically once the battery has achieved its maximum charge.
Cleaning the MVP-TCS-52
You should clean the Table Charging Station after each day’s use to maintain the device’s appearance.
Always use a clean cotton cloth and a spray bottle containing water or a vinegar-based cleaner, as
alcohol-based cleaners can damage the device. Do not directly spray the device: instead, spray the cloth
to prevent moisture from collecting on the charger pins. Do NOT use an abrasive of any type to clean the
Table Charging Station, as this may permanently damage or remove the device’s finish.
FIG. 6 MVP-5200i in MVP-TCS-52-GB Table Charging Station
FIG. 7 MVP-TCS-52-GW Table Charging Station - Rear
MVP-5200i device
Table Charging
Charging station
rear support
Station
Charger pins
Charging Station cradle