AMX MODERO VIEWPOINT WIDESCREEN TOUCH PANEL MVP-5200I User Manual
Page 22
Accessories
14
MVP-5200i Modero Viewpoint Widescreen Touch Panel
7.
Secure the power cable to the device, using either of the two tie-wrap anchors included in the
Installation Kit at the top rear of the device (FIG. 12). Point the head of each tie wrap toward the
center of the device.
8.
Firmly seat the mini-captive wire connector to the power connector on the device.
9.
Firmly seat the device against the conduit box. Make sure that the tab connector at the top of the
device is locked into the conduit box.
10.
Insert the two installation screws from the MVP-WCS-52 Installation Kit into the screw holes in the
interior compartment of the device and tighten them to anchor the device to the conduit box.
FIG. 12
MVP- WCS-52 - Rear
Tie-Wrap Anchors
Mini-Captive Wire
Connector Plug
(female)