Sony STR-DA3600ES - Manual (Page 104)

104 GB
2
Press AMP.
The ZONE button goes off, the AMP
button keeps flashing and the SHIFT
button lights up.
3
Press the numeric button 1 or 2
while the AMP button is
flashing.
When you press 1, the command mode is
set to AV SYSTEM 1. When you press 2,
the command mode is set to AV SYSTEM
2.
The AMP button lights up.
4
Press ENTER.
The AMP button flashes twice, then the
command mode setting process is
completed.
Using a bi-amplifier
connection
If you are not using surround back speakers
and front high speakers, you can use the
SURROUND BACK/FRONT HIGH/ZONE 2
terminals for the front speakers for use with a
bi-amplifier connection.
To connect speakers
Connect the jacks on the Lo (or Hi) side of the
front speakers to the FRONT A terminals,
and connect the jacks on the Hi (or Lo) side of
the front speakers to the SURROUND BACK/
FRONT HIGH/ZONE 2 terminals. Make sure
that metal fittings of Hi/Lo attached to the
speakers have been removed from the
speakers. Not doing so may cause a
malfunction of the receiver.
To set up speakers
1 Select “ Settings” from the menu,
then press or b.
2 Select “Speaker,” then press or b.
3 Select “Speaker Pattern,” then press
.
Front speaker
(R)
Front speaker
(L)
Hi
Lo
Hi
Lo