Sony STR-DA3600ES - Manual (Page 96)

96 GB
5
Select “Control for HDMI,” then
press
or b.
6
Select “ON,” then press .
The Control for HDMI function of the
receiver is activated.
7
Press GUI MODE to exit the GUI
menu.
If the GUI menu is displayed, the Control
for HDMI function of the playback
components will not work properly.
8
Press one of the HDMI input
buttons to display the image of
the playback components for
which you want to set the
Control for HDMI function.
9
Turn the Control for HDMI
function of the connected
component on.
For details on setting the connected
component, refer to its operating
instructions.
10
Repeat steps 8 and 9 to set the
Control for HDMI function and
to display the image of all the
playback components you want
to use.
Notes
• When you pull out the HDMI cable or change the
connection, perform the steps above.
• When you assign the component video input to the
HDMI input using the Input Assign function, you
cannot set “Control for HDMI” to “ON.”
By a simple operation (one-touch),
components connected to the receiver with
HDMI connections start automatically.
You can enjoy the sound/image using
connected components.
When you set
“ Pass Through ” to “ ON, ” sound
and image can be output only from the TV
while the receiver remains in standby mode.
Play back a connected component.
The receiver and TV are turned on
simultaneously, and sound and image are
output from the receiver and TV.
Note
Depending on the TV, the start of the content may
not be output.
You can enjoy the TV sound from the speakers
connected to the receiver by a simple
operation.
Depending on the TV settings, while you are
watching the TV, the receiver turns on and
switches to the “TV” function automatically.
TV sound is output from the speakers
connected to the receiver, and the volume of
the TV is minimized simultaneously.
You can use the System Audio Control
function as follows.
• The sound of the TV is output from the
speakers connected to the receiver when you
turn the receiver on while the sound is being
output from the TV speaker.
• You can adjust the receiver’s volume when
you adjust the TV volume.
You can also operate this function using the
TV menu. For details, refer to the operating
instructions of the TV.
Notes
• When “Control for HDMI” is set to “ON,” the
“Audio Out” settings in the HDMI settings menu
will set automatically depending on the System
Audio Control settings.
• When you connect a TV that does not have System
Audio Control function, the System Audio Control
function does not work.
Playing back components with
one-touch operation (One-Touch
Play)
Enjoying the TV sound from the
speakers connected to the
receiver (System Audio Control)