Sony STR-DA3600ES - Manual (Page 111)

111 GB
Adju
stin
g Setti
ngs
You can select the test tone type on the Test
Tone screen.
Tips
• To adjust the level of all speakers at the same time,
press MASTER VOLUME +/–.
• The adjusted value is shown on the display during
adjustment.
To output a test tone from each
speaker
You can output a test tone from the speakers in
sequence.
1 Select “Test Tone,” then press .
The Test Tone screen appears.
2 Adjust the parameter, then press .
• OFF
• AUTO
The test tone is output from each speaker
in sequence.
• L, C, R, SR, SB*, SBR, SBL, SL, LH,
RH, SW
* “SB” appears when only one surround back
speaker is connected.
You can select which speakers will output
the test tone.
3 Adjust “Level:,” then press .
To output a test tone from
adjacent speakers
You can output a test tone from adjacent
speakers so that you can adjust the balance
between the speakers.
1 Select “Phase Noise,” then press .
The Phase Noise screen appears.
2 Adjust the parameter, then press .
• OFF
• L/C, C/R, R/SL, R/SR, SR/SL, SR/SBR,
SR/SB*, SBR/SBL, SB/SL*, SBL/SL,
SL/L, L/SR, L/RH, LH/RH, LH/R
* “SR/SB” and “SB/SL”appear when only one
surround back speaker is connected.
Lets you output the test tone sequentially
from adjacent speakers.
Some items may not be displayed,
depending on the setting of the speaker
pattern.
3 Adjust “Level:,” then press .
To output the source sound
from adjacent speakers
You can output the source sound from adjacent
speakers so that you can adjust the balance
between the speakers.
1 Select “Phase Audio,” then press .
The Phase Audio screen appears.
2 Adjust the parameter, then press .
• OFF
• L/C, C/R, R/SL, R/SR, SR/SL, SR/SBR,
SR/SB*, SBR/SBL, SB/SL*, SBL/SL,
SL/L, L/SR, L/RH, LH/RH, LH/R
* “SR/SB” and “SB/SL”appear when only one
surround back speaker is connected.
Lets you output front 2 channel source
sound (instead of the test tone)
sequentially from adjacent speakers.
Some items may not be displayed,
depending on the setting of the speaker
pattern.
3
Adjust “Level:,” then press .
Note
When Dolby TrueHD, or Linear PCM signals with a
sampling frequency of 176.4 kHz and higher are
being received, sound is output only from the front
left/right speakers.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely. Check to see if they are connected
securely and cannot be disconnected by
pulling on them slightly.
• The speaker cords may have the short-circuit
problem.
Test Tone
continued