Sony STR-DA3600ES - Manual (Page 120)

120 GB
Notes
• The sound quality of the playback component
depends on the TV’s sound quality, such as the
number of channels, and the sampling frequency,
etc. When the TV has stereo speakers, the sound
output from the receiver is also stereo as that of the
TV, even if you play multi-channel source.
• When you connect the receiver to a video
component (projector, etc.), sound may not be
output from the receiver. In this case, select
“AMP.”
• When you select the input that you have assigned
the HDMI input, sound is not output from the TV.
x AMP
The HDMI audio signals from the playback
component is only output to speakers
connected to the receiver. The multi-channel
sound can be played back as it is.
Note
Audio signals are not output from the TV speaker
when “Audio Out” is set to “AMP.”
Lets you set the level of the subwoofer to 0 dB
or +10 dB when PCM signals are input via an
HDMI connection. You can set the level for
each HDMI input independently.
x 0 dB
x AUTO
Automatically sets the level to 0 dB or +10 dB
depending on the audio stream.
x +10 dB
Lets you turn the low-pass filter for the
subwoofer output on or off. The low-pass filter
works when PCM signals are input via an
HDMI connection. Turn the function on if you
connect a subwoofer without the crossover
frequency function.
x OFF
Does not activate the low-pass filter.
x ON
Always activates the low-pass filter with a
cutoff frequency of 120 Hz.
Subwoofer Level
Subwoofer LPF