Sony STR-DA3600ES - Manual (Page 48)

48 GB
3
Press V/v repeatedly to select
“Auto Calibration,” then press
.
4
Press V/v repeatedly to select
“Calibration Start,” then press
.
The screen on which you can select the
item to be measured appears.
5
Press V/v repeatedly and to
un-check the items you do not
want to measure, then press
b.
The confirmation screen, asking whether
you are ready to start measurement,
appears.
6
Press to select “Start.”
The measurement starts in five seconds.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
When the measurement ends, a beep
sounds and the screen switches.
7
Press V/v repeatedly to select
the item you want, then press
.
Item Explanation
Retry Performs auto calibration
again.
Save Saves the measurement
results and exits the setting
process. See “Saving the
measurement results”
(page 49).
Warning Displays warning
concerning the
measurement results. See
“Message list after auto
calibration measurement”
(page 50).
Phase Displays the phase of each
speaker (in phase/ out of
phase).
Distance Displays the measurement
result for speaker distance.
Level Displays the measurement
result for speaker level.
Exit Exits the setting process
without saving the
measurement results.