American Power Conversion AIRACPA4000 - Manual (Page 3)

® ® ® ®
ADDENDUM
NetworkA
IR ACPA4000
2
System requirements
The Wizard runs on Windows
®
98, Windows NT
®
, Windows 2000,
Windows 2003, and Windows XP Intel-based workstations.
Configuring Network Management Card settings
Using the Wizard, you can configure basic settings locally or remotely for
the Network Management Cards. The Wizard cannot configure the
following settings for the Network Management Card:
• Event action settings
• Email settings
• DNS settings
Installing the Wizard
If autorun is enabled on your CD drive, a page will open automatically in
your browser when the CD is inserted. Navigate to the Management Card
Wizard page, and select
Install the Wizard . Otherwise, run the setup.exe
installation program found in the Wizard directory and follow the on-screen
instructions. During installation, a shortcut link is created in the
Start menu.
Use this link to launch the Wizard application.
Online Help
To access the Wizard’s online help, click Help at the lower left on the
Wizard screen.
The Network Management Card Wizard uses FTP to transfer files.
If you are using Secure CoPy (SCP) and have disabled the FTP
server, you must temporarily enable it to use the Wizard to
configure settings of a Network Management Card.