American Power Conversion AIRACPA4000 - Manual (Page 9)

® ® ® ®
ADDENDUM
NetworkA
IR ACPA4000
8
Reconfiguring deployed Network Management
Cards
1. Use the link in the Start menu to launch the Wizard application, and
then click Next > on the opening screen.
2. Select the Custom (Advanced) option from the “Installation Options”
screen, and then click Next > .
3. Select the Define a New Configuration File (Typical) option from the
“Custom Installation” screen, and then click Next > .
4. Click Next > as many times as needed to cycle through the Network
Management Card’s settings. Bypass any setting that you do not want
to configure.
5. Stop at the “Customize the settings that will be transmitted to the
Management Card” screen, and choose the settings to transmit to the
Network Management Cards. (Choose only settings that are generic
across multiple Network Management Cards.) Then click
Next > .
To perform this procedure, the FTP server must be enabled.
Because the Wizard uses FTP to reconfigure Network
Management Cards, do not disable
FTP Server Access .
Deselect the TCP/IP settings ( System IP , Subnet Mask ,
Default Gateway addresses, and BOOTP ) and FTP Server
Access settings so that they will not overwrite these
settings when you transfer the new settings.