American Power Conversion AIRACPA4000 - Manual (Page 6)

® ® ® ®
ADDENDUM
NetworkA
IR ACPA4000
5
Using the Network Management Card Wizard
Configuring the required TCP/IP settings
To configure the Network Management Card’s required TCP/IP settings
remotely:
1. Contact your network administrator to obtain valid TCP/IP settings.
2. From the Start menu, launch the Wizard application. The Wizard
automatically detects any unconfigured Network Management Cards.
3. Select the Express (Recommended ) option from the “Installation
Options” screen, and then click Next > .
4. Select the Remotely (over the Network) option from the “Express
Configuration” screen, and then click Next > .
5. When the Wizard prompts you for the TCP/IP settings, configure the
settings ( System IP , Subnet Mask , and Default Gateway addresses).
6. Select the Start a Web browser when finished option to connect over
the Web to the NetworkAIR PA Portable Air Conditioner. This launches
the default Web browser. Click
Finish and wait for a few seconds to let
the Management Card restart, which will not interrupt power to the air
conditioner.
7. After you enter the correct, IP -formatted information, click Finish to
transmit the TCP/IP settings. The Wizard checks to see if the System IP
address you entered is in use on the network. If it is discovered as an
IP address in use, enter a valid IP address, click Finish , and follow the
on-screen instructions.