Dubbing a tape easily – easy dubbing, 4) confirming the vcr operation, When the vcr does not operate correctly – Sony DCR-TRV250 User Manual

Page 102

Advertising
background image

102

E A S Y D U B B I N G
S E T U P
I R S E T U P
P A U S E M O D E
I R T E S T
R E T U R N

R E A D Y

0

0

:

0

0

:

0

E A S Y D U B B I N G
S E T U P
I R S E T U P
P A U S E M O D E
I R T E S T
R E T U R N

E N G A G E
R E C P A U S E

R E T U R N
E X E C U T E

0

0

:

0

0

:

0

N O R M A L

N O R M A L

2

[ E A S Y D U B ] : E N D

[ E A S Y D U B ] : E N D

(4) Confirming the VCR operation

1

Insert a recordable tape into the VCR, then set the VCR to recording pause.

2

Turn the SEL/PUSH EXEC dial to select IR TEST, then press the dial.

3

Turn the SEL/PUSH EXEC dial to select EXECUTE, then press the dial.

If the VCR starts recording, the setting is correct.
When recording is finished, the indicator changes to COMPLETE.

(3) Setting your camcorder and the VCR to face each other

Locate the infrared rays emitter of your camcorder and face it towards the remote
sensor of the VCR.
Set the devices about 30 cm (12 in.) apart, and remove any obstacles between the
devices.

When the VCR does not operate correctly

• After checking the code in “About the IR SETUP code,” set IR SETUP or

PAUSE MODE again.

• Place your camcorder at least 30 cm (12 in.) away from the VCR.
• Refer to the operating instructions of your VCR.

Dubbing a tape easily – Easy Dubbing

CCD-TRV418

Remote sensor

Infrared rays emitter

A/V connecting
cable (supplied)

CCD-TRV418

VCR

Advertising
This manual is related to the following products: