Sony DCR-SR220 - Manual (Page 81)

Troubleshooting
81

The recording media is full. Delete
unnecessary images (p. 38).

Total number of movies or still images
exceeds the recordable capacity of the
media (p. 62, 92). Delete unnecessary
images (p. 38).

While [DROP SENSOR] (p. 69) is
activated, you cannot record images.

You cannot record images in sleep mode.
Cancel QUICK ON (p. 27).

Your camcorder is recording the image you
have just shot onto the media. You cannot
make a new recording during this period.

The temperature of your camcorder is
extremely high. Turn off your camcorder
and leave it for a while in a cool place.

The temperature of your camcorder is
extremely low. Turn off the camcorder
and take it to a warm place. Leave the
camcorder there for a while, then turn on
the camcorder.
You cannot record a still image.

You cannot record a still image together
with:

[SMTH SLW REC]

[FADER]

[D.EFFECT]

[PICT.EFFECT]
The ACCESS lamp remains lit even
when you stop recording.

Your camcorder is recording the image you
have just shot on the media.
The recording angle looks different.

Recording angle may vary depending on
the condition of the camcorder. This is not
a malfunction.
The flash does not work.

You cannot use the flash when you capture
still images while recording a movie.

Even if auto flash or (Auto redeye
reduction) is selected, you cannot use the
flash with:

NightShot

[SUPER NIGHTSHOT]

[TWILIGHT], [CANDLE],
[SUNRISE&SUNSET], [FIREWORKS],
[LANDSCAPE], [SPOTLIGHT],
[BEACH] or [SNOW] in [SCENE
SELECTION]

[MANUAL] in [EXPOSURE]

[SPOT METER]
The actual recording time for movie is
less than the expected approximate
recording time of the media.

Depending on the recording conditions,
the time available for recording may be
shorter, for example when recording a fast
moving object, etc (p. 58).
The recording stops.

The temperature of your camcorder is
extremely high. Turn off your camcorder
and leave it for a while in a cool place.

The temperature of your camcorder is
extremely low. Turn off the camcorder
and take it to a warm place. Leave the
camcorder there for a while, then turn on
the camcorder.

If vibrations occur continuously, recording
may stop.
There is a time difference between the
point where you press START/STOP
and the point that movie recording
starts/stops.

On your camcorder, there may be a slight
time difference between the point where
you press START/STOP and the actual
point that movie recording starts/stops.
This is not a malfunction.
The auto focus does not function.

Set [FOCUS] to [AUTO] (p. 73).

The recording conditions are not suitable
for auto focus. Adjust the focus manually
(p. 73).