Sony DCR-SR220 - Manual (Page 86)

86
Warning indicators and messages
Self-diagnosis display/Warning
indicators
If indicators appear on the LCD screen,
check the following.
If the problem persists even after you have
tried a couple of times, contact your Sony
dealer or local authorized Sony service
facility.
C:04:00
C:(or E:) : (Self-diagnosis
display)
C:04:

The battery pack is not an “InfoLITHIUM”
battery pack (H series). Use an
“InfoLITHIUM” battery pack (H series)
(p. 94).

Connect the DC plug of the AC Adaptor to
the DC IN jack of the Handycam Station or
your camcorder securely (p. 13).
C:13: / C:32:

Remove the power source. Reconnect it
and operate your camcorder again.

Turn on your camcorder again.
E:20: / E:31: / E:61: /
E:62: / E:91: / E:94:

A malfunction that you cannot service has
occurred. Contact your Sony dealer or local
authorized Sony service facility. Inform
them of the 5-digit code, which starts from
“E.”
101-0001 (Warning indicator
pertaining to files)
Slow flashing

The file is damaged.

The file is unreadable.
(Warning on the hard disk of the
camcorder)*
Fast flashing

An error may have occurred with the hard
disk drive in your camcorder.
(Warning on the hard disk of the
camcorder)*
Fast flashing

The hard disk of the camcorder is fully
recorded.

An error may have occurred with the hard
disk drive in your camcorder.
 (Battery level warning)
Slow flashing

The battery pack is nearly used up.

Depending on the operating environment
or battery conditions,  may flash, even
if there are approximately 20 minutes
remaining.
(High temperature warning)
Slow flashing

The temperature of your camcorder is
getting higher. Turn off your camcorder
and leave it for a while in a cool place.
Fast flashing*

The temperature of your camcorder is
extremely high. Turn off your camcorder
and leave it for a while in a cool place.
(Low temperature warning)*
Fast flashing

The temperature of your camcorder is
extremely low. Make the camcorder warm.