Water supply & installation – Alto-Shaam 1220 User Manual

Page 29

Advertising
background image

COMbIThERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 27.

i n s t a l l a t i o n

w a t e r c o n n e c t i o n s

water supply & installation

water requirements

two (2) cold water inlets - drinking quality

one (1) treated water inlet:

3/4” npT*

one (1) untreated water inlet:

3/4” npT*

line pressure:

30 to 90 psi

2.8 to 6.2 bar

* Can manifold off of one 3/4” line

REFER TO PUBLISHED SPECIFIC WATER REQUIREMENTS

water drain:

1-1/2” connection with air gap

Flush the water line at the installation site.
install water intake filters (provided) [see Figure 1]

before connecting the oven to the water supply.
a hose connector is supplied for flexible hose

connection to the COLD water source.
Backflow Prevention — The equipment must be

installed with adequate backflow protection to

comply with applicable federal, state, and local

codes.
PiPe sealing taPe (

teFlon®

) must be used

at all connection Points. The use of a pipe

sealing compound is not recommended.

Incoming cold

water connection

T connection

Cold water line

to untreated

oven connection

Cold water

line to filter

or treatment

system

Water Filter

Install water

intake filters

Figure 1

one suggested

method of installation

note:

both treated and untreated
water connections must
be connected For ProPer
oPeration oF the oven.
both connections can be
treated water, but should
never be connected to only
untreated water.

unions or FleXible lines
should be used to allow For
oven movement when being
serviced or cleaning
is needed.

CombiGuard™

FI-23014 shown

alto-shaam now offers an improved water
filtration system for combitherm

®

. The

combiguard™ 10 & 20 triple-guard water
filtration system filters dirt, sediment, and other
debris as small as 1/2 micron. This system also significantly reduces
chlorine content to protect against corrosive chorine compounds.
combiguard improves equipment efficiency, reduces service requirements
and extends the life of the combi oven. after installation, confirm that
water quality standards specified in this manual are being met. Filtration
systems include one filter cartridge. additional cartridges can be purchased
separately. refer to an earlier page for additional ordering information.

The combiguard™ Bws Blended water system utilizes reverse osmosis to
remove more than 97% of the total dissolved solids from water which can be
precisely blended with filtered and treated water.

Treated cold water

to backflow preventer

to treated connection

on oven

Advertising
This manual is related to the following products: