Alto-Shaam 1220 - Manual (Page 36)

COMbIThERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 34.
i n s t a l l a t i o n
v e n t l e s s h o o d o p t i o n
The Ventless hood option is factory installed directly on
the top of the alto-shaam combitherm oven. The hood is
designed to vent clean air back into the kitchen, filtering
vapors and grease. a high-power fan draws steam and
fumes into the hood intake and out the top surface exhaust
vent. Fumes and vapors are circulated through filters
draining the condensation through a drain at the rear of
the hood. an activated charcoal filter cleans the air before
venting it out the top of the hood.
condensate drain
a ventless hood condensate drain line to the floor drain
must be installed. The 3/4" npT thread connection is
found at the back of the hood. The drain line must always
be a positive gradient away from the combitherm.
filter door latch
using a coin or screwdriver, turn to open;
reverse procedure to close and latch.
hood and oven will not operate unless this is
closed properly.
TOP LEVEL ASSY, VHES-5 HOOD
FOR COMBI
5010692