Albatron Technology KI51PV-754 - Manual (Page 24)

Mainboard KI51PV-754
20
Chapter 2. BIOS Setup
Introduction
This section describes PHOENIX-AWARD™ BIOS Setup program which resides in the BIOS
firmware. The Setup program allows users to modify the basic system configuration. The
configuration information is then saved to CMOS RAM where the data is sustained by battery
after power-down.
The BIOS provides critical low-level support for standard devices such as disk drives, serial
ports and parallel ports. As well, the BIOS control the first stage of the boot process, loading
and executing the operating system.
The PHOENIX-AWARD TM BIOS installed in your computer system’s ROM is a custom version
of an industry standard BIOS. This means that it supports the BIOS of AMD based processors.
This version of the PHOENIX-AWARD TM BIOS includes additional features such as virus and
password protection as well as special configurations for fine-tuning the system chipset. The
defaults for the BIOS values contained in this document may vary slightly with the version
installed in your system.
Key Function
In general, you can use the arrow keys to highlight options, press <Enter> to select, use the
<PgUp> and <PgDn> keys to change entries, press <F1> for help and press <Esc> to quit. The
following table provides more detail about how to navigate within the BIOS Setup program.
Keystroke Function
Up arrow Move to previous option
Down arrow Move to next option
Left arrow Move to the option on the left (menu bar)
Right arrow Move to the option on the right (menu bar)
Esc Main Menu: Quit without saving changes
Submenus: Exit Current page to the next higher level menu
Move Enter Move to the option you desire
PgUp key Increase the numeric value or enter changes
PgDn key Decrease the numeric value or enter changes
+ Key Increase the numeric value or enter changes
- Key Decrease the numeric value or enter changes
Esc key Main Menu – Quit and do not save changes into CMOS
Status Page Setup Menu and Option Page Setup Menu – Exit
Current page and return to Main Menu
F1 key General help on Setup navigation keys
F5 key Load previous values from CMOS
F6 key Load the defaults from BIOS default table