Albatron Technology KI51PV-754 - Manual (Page 53)

Mainboard KI51PV-754
49
Install the OS of Windows ® 2000/XP into your RAID HDDs
In this section, it will tell you how to install the operating system of Windows ® 2000/XP into your
RAID drives. The installation steps below will assume that your HDDs have already been
attached to either the PATA or SATA connectors, and also your BIOS RAID Utility has already
been configured (see NVIDIA BIOS RAID Utility Configuration section).
Preparation: Before starting to install the OS, copy the “RAID Driver” and associated files from
the bundle CD Driver to an empty floppy disk [The files location in CD-ROM => \ Driver \ nForce
\ 6.53 \ IDE \ Floppy \ *.*]. This will have to be done on another system if you are installing the
system from scratch.
1. During Windows installation, the “Windows Setup” screen will prompt you with “Press F6 if
you need to install third party SCSI or RAID driver”. Press <F6>.
2. Press 's' when setup asks if you want to specify an additional device. Insert the floppy disk
which includes the “RAID Driver” into the floppy drive. Press 'Enter' and select the appropriate
OS device driver.
3. Press 'Enter' again to continue the setup process.
4. Follow the setup instructions and select your choice for partition and file system.
5. After setup examines your disks, it will copy files to the Windows ® 2000/ XP installation
folders and restart the system. After the system is rebooted the setup program will continue with
the installation all the way to completion.
6. Wait until Windows ® 2000/ XP finishes installing devices, regional settings, networking
settings, components, and the final set of tasks. Reboot the system if you are asked to do so.