Albatron Technology KI51PV-754 - Manual (Page 37)

Mainboard KI51PV-754
33
When this option is enabled, each of the ranges is from 1 minute to 1 hour except for HDD
Power Down, which ranges from 1 minute to 15 minute and includes a “disable” option.
Note: If you select Min. or Max. Power Saving modes, the “HDD Power Down” value will be
fixed. User Define, Min Saving, Max Saving
Video Off Method
This option determines the manner in which the monitor goes blank.
Options:
Blank Screen This option only writes blanks to the video buffer.
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
DPMS Support (Default) Initial display power management signaling.
HDD Power Down
When enabled, the hard disk drive will power down after a certain configurable period of system
inactivity. All other devices remain active.
Options: Disabled (Default), 1 Min, 2 Min, 3 Min, 4 Min, 5 Min, 6 Min, 7 Min, 8 Min, 9 Min, 10 Min,
11 Min, 12 Min, 13 Min, 14 Min, 15Min.
HDD Down In Suspend
This option allows you to enable/ disable the hard driver power down in the suspend state.
Options: Disabled (Default), Enabled.
Soft-Off by PWRBTN
In situations where the system enters a “hung” state, you can configure the BIOS so that you
are required to press the power button for more than 4 seconds before the system enters the
Soft-Off state. Options: Delay 4 Sec, Instant-Off (Default).
PCI PME Wake Up
This option will also cause the system to wake up with any onboard LAN activity.
Options: Disabled (Default), Enabled.
Ring Wake Up
This option allows you to awaken the system upon receiving an incoming call from a modem
device. Options: Disabled (Default), Enabled.
RTC Wake Up
When “Enabled”, you can set the date and time at which the RTC (real-time clock) alarm
awakens the system from Suspend mode. Options: Enabled, Disabled (Default).
Day of Month Alarm