Merrychef 402s - Manual (Page 3)

402s Ovens Pt. No. 32Z3522 Issue 6
3
CAUTION
WARNING TO SERVICE TECHNICIANS
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING
SERVICING TO AVOID POSSIBLE EXPOSURE TO
EXCESSIVE MICROWAVE ENERGY
(a) Do not operate or allow the oven to be operated with the door open.
(b) Make the following safety checks on all ovens to be serviced before
activating the magnetron or other microwave source, and make repairs
as necessary:
1) interlock operation.
2) proper door closing.
3) seal and sealing surfaces (arcing, wear, and other damage).
4) damage to or loosening of hinges and latches.
5) evidence of dropping or abuse.
(c) Before turning on microwave power for any service test or inspection
within the microwave generating compartments, check the magnetron,
wave guide or transmission line, and cavity for proper alignment,
integrity and connections.
(d) Any defective or misadjusted components in the interlock, monitor, door
seal, and microwave generation and transmission systems shall be
repaired, replaced, or adjusted by procedures described in this manual
before the oven is released to the owner.
(e)
(i) For U.S.A.
A microwave leakage check to verify compliance with the Federal
Performance Standard should be performed on each oven prior to
release to the owner.
(e) (ii) For CANADA.
A microwave leakage check to verify compliance with the Canadian
Regulation, HEALTH AND WELFARE, SOR/79 920 should be performed
on each oven prior to release to the owner.
MICROWAVE SAFETY PRECAUTIONS