Power Soak 29222 INSTRUCTIONS INSTALLATION PS-200 - Manual (Page 11)

7
Component Installation
Lay the sink on its back to allow access to the bottom of the tanks. Be
careful to not let the sink assembly drop on the floor with an impact that
would damage the sink assembly or the floor. It may be necessary to
place some cardboard or tarp on the floor to protect the finish.
The sink must be accessible from its top side and its bottom side in order
to install the accessories. Be aware that the backsplash is unsupported at
this time and can be bent out of shape by trying to support the entire
weight of the sink on the edge of the backsplash.
Install Sink Drains
There are three sink drains in the Power Soak that must be installed. The
drain with a valve built into the body is installed in the bottom of the tank
and oriented with the drain valve handle toward the front of the sink. Each
drain flange must be sealed to its mating surface in the sink.
DRAIN WITH BUILT-IN
VALVE IS INSTALLED
IN THE BOTTOM OF
THE TANK
Do not bend the edge of
the backsplash when
laying the sink on its back
side.
IMPORTANT