Power Soak 29222 INSTRUCTIONS INSTALLATION PS-200 - Manual (Page 12)

8
Apply a generous bead of a drain sealant around the lip of the drain body.
The drains with built-in valves will be oriented with the handle connection
toward the front of the sink. From inside the sink, insert the drain through
the drain hole and seat the flange against the sheet metal surface of the
tank. Be sure that the sealant compresses to where the rim of the drain
actually touches the sheet metal surface of the sink. If the drain does not
touch the sink it will work loose and leak as the sealant compresses over
time.
From the outside of the tank place the rubber vibration ring over the
threaded body of the drain followed by the Teflon ring and then the drain
nut. Tighten the nut “hand tight” until the handle is installed.
DRAIN BODY
APPROVED
DRAIN
SEALANT
RUBBER VIBRATION RING
TEFLON RING
FLANGE NUT
HANDLE CONNECTION
ORIENTED TOWARD THE
FRONT OF THE MACHINE.
BOTTOM OF SINK (Sink is laying
on its back side in this illustration)
THE RIM OF THE DRAIN MUST
SEAT ON THE SURFACE OF THE
SINK OR IT WILL WORK LOOSE
OVER TIME AND ALLOW WATER
TO LEAK AROUND THE DRAIN
IMPORTANT