Power Soak 29222 INSTRUCTIONS INSTALLATION PS-200 - Manual (Page 14)

10
Install Legs
The Power Soak is usually shipped without the leg assembly attached to
the machine. Different options have different types of leg assemblies.
Some leg assemblies are all welded together and others are pieces that
need to be assembled. If the leg set is welded together, skip to the section
labeled “Leg Set and Sink”.
Leg Set Assembly
Locate the two leg end weldments and stretcher. The stretcher is the
horizontal tube that connects between the legs to provide lateral stability to
the legs. The long stretcher will be installed between the back legs of the
wash tank.
Orient the stretcher socket with the set screw facing toward the interior of
the sink and then slide the stretcher sockets over the top of the leg sets so
that the stretcher will be positioned above the welded joint of the leg when
the legs are assembled onto the sink. Install the long stretcher and the
other stretcher between the leg sets by inserting it into the sockets before
inserting the legs into the sockets on the bottom of the tanks.
INSTALL THE LONG STRETCHER
UNDER THE WASH SINK.
INSTALL THE SOCKETS ABOVE
THE WELD JOINT PRIOR TO
INSERTING THE LEG WELDMENT
INTO THE SOCKETS ON THE
BOTTOM OF THE SINK.
LEG END
WELDMENT