Power Soak 29222 INSTRUCTIONS INSTALLATION PS-200 - Manual (Page 19)

15
Faucet Installation
Open the faucet package and locate the water connection elbows, faucet
body and escutcheon assemblies. Apply Teflon tape to the threads of the
elbows and insert them though the backsplash of the sink.
Loosely fit the escutcheons to the elbows and the faucet body. When the
alignment of the body with the sink is confirmed, tighten the escutcheons
onto the elbows and faucet body. From the back side of the backsplash,
tighten the brass nuts on the elbows when the faucet body is parallel with
the rim of the sink.
Complete the faucet assembly according to the manufacturer’s instructions
which are included with the faucet. Attach water lines to the faucet so that
the lines extend below the sink. This will make the plumbing easier to
complete when the machine is placed against the wall.
Escutcheon
screwed onto
the elbow Elbow inserted
from the back
side of the
backsplash
Wrap the elbow
threads with
Teflon tape
Faucet must be parallel
with the drain board or rim
of the sink