Power Soak 29222 INSTRUCTIONS INSTALLATION PS-200 - Manual (Page 22)

18
Final Installation Steps
Machine Placement
Position the Power Soak so that the back splash rests against the wall and
is placed according to the floor plan or customer’s selected location.
Examine the drain and water supply lines to determine that the plumbing
can be completed when the Power Soak is in the final location. Verify that
the plumbing from the faucet can be reached with the sink against the wall.
Downturned-Backsplash Z-Clip Installation
If the Power Soak
®
system has an upturned backsplash, skip this step.
If the Power Soak
®
system has a backsplash that is downturned, attach the
provided Z-Clips to the wall using the following procedure. Using a level,
adjust the feet on the Power Soak until the front rim and the rear rim of the
sink are level. The sink must also be level front to back. Measure from the
floor to the top edge of the backsplash, and then move the sink away from
the wall. Locate Z-Clips by marking a level line on the wall approximately
1/16" to 3/32" below the height of the backsplash top edge. Locate the wall
studs and mark the locations. Align top edge of Z-Clip(s) to the marked
line and securely fasten the Z-Clips to the wall, using fasteners provided.
Install screws directly to the walls' studs whenever possible. The Z-Clips
should be space as evenly as possible. Move the sink to the wall and lift
the back edge over the Z-Clips.
Upturned-Backsplash Level Attach to the Wall
If the Power Soak
®
system has a downturned backsplash, skip this step.
Using a level, adjust the feet on the Power Soak until the front rim and the
rear rim of the sink are level. The sink must also be level front to back.
Locate the wall studs and mark their location on the top edge of the back
splash. Measure down ¾” from the top of the backsplash and then drill ¼”
diameter holes through the back splash in line with the center of the studs.
Use the #10 stainless steel screws (included with the Power Soak) to
attach the Power soak directly to the wall.
The Power Soak sink assembly must be level from side to side and
front to rear with all the feet making firm contact with the floor.
IMPORTANT