Vaddio ZoomSHOT WallVIEW USB - Manual (Page 13)

ZOOMSHOT WallVIEW USB Camera System
ZoomSHOT WallVIEW USB System Document Number 342-0640 Rev. B Page 13 of 40
Compatible with USB 2.0 UVC Drivers
The USB 2.0 UVC (Universal Video Class) video driver resolution table is an internal list of resolutions available
for the Host PC and the Quick-Connect USB to negotiate and use for any approved/tested USB application.
Typically, the highest resolution possible between both the PC and Quick-Connect USB is used. However, not all
OS and application combinations are altogether typical.
Table: Supported UVC Resolutions
Format Resolution Frame Rate Aspect Ratio
MJPEG 1280 x 720 15/30 16:9
960 x 544 15/30 16:9
704 x 576 15/30 4:3
640 x 480 15/30 4:3
640 x 360 15/30 16:9
424 x 240 15/30 4:3
352 x 240 15/30 4:3
320 x 240 15/30 4:3
320 x 180 15/30 16:9
I NTERNAL W EB P AGES AND C ONTROL
The internal web pages will allow control of the Quick-Connect USB and control of the attached camera via a
network connection. These web pages will allow the user or administrator to set security passwords, change the
IP address, view diagnostics, access the firmware upgrade page and more!
DHCP IP Set-up (Dynamic Host Configuration Protocol)
DHCP Set-up (skip this section if Static IP). If the LAN has a DHCP (dynamic host configuration protocol) server, then the IP address,
gateway and routing information will automatically be assigned. The QC-USB software is defaulted to DHCP and will attempt to dynamically
obtain an IP address using DHCP, but it will fall back to the default address of 169.254.1.1 if no DHCP server can be found.
Static IP Set-up:
The static IP can be assigned either through the network or directly with a computer using a cross-over cable. Depending on the age of the
computer, you may not need a cross-over cable. Either way the steps are the same for network or direct connection to a computer. The
default address of the QC-USB camera is 169.254.1.1 and the Subnet mask is 255.255.0.0. Different computer OS types all have their own
way of doing things (without question), but they are essentially doing the same stuff, changing the IP address so the web pages of the HD-
USB are accessible
.
Quick-Connect USB Web Pages Tour:
Screen Shot: Login
The QC-USB web server is intended as a user’s camera control page at one level, and an administrator’s
management tool at another level, which requires password authentication for access.
The Login Page will appear if there is a username assigned by the administrator. Assigning a username can limit
access to the admin menus by a general user. By default, the username is blank and the password for the user
account is: password. The Administrator can set the name and password for the user account. If no username
is assigned, the web page will automatically open to the Camera Control page.
Defaults:
Username is blank
(assigned by admin)
Password is: password
Admin name is: admin
Password is: password