Pathway DMX Dart Users Manual - Manual (Page 15)

DMXDart Operation
15
NOTE: Changing the way that levels display, also changes they way levels
are entered from the keypad.
2 – Hex
This function adds the hexadecimal value of the level selected to the levels
display. When this method of display is selected, the hexadecimal level is shown
to the right of the (% or D) level display, next to the level information. The letter
H follows the hexadecimal level.
Transmit DMX512 Transmit DMX512
Accepted Accepted
CH 001 @ 16% 29H CH 001 @ 16% 29H
^ ^
Use the Ý and Þ buttons to turn the hexadecimal display mode on or off, then
press MENU to return to the Setup menu.
3 – Bump
Use this function to set the level and fade time parameters for the BMP (Bump)
key operation. Use the Ý and Þ or the keypad buttons to set the level you want
to bump to when the BMP button is pressed, then press Ü to move to the fade
time parameter (T:). Use the Ý and Þ buttons or the keypad to set the fade time
you want to use for the bump function. Any fade time from 0.0 to 9.9 seconds
can be set. Press MENU to return to the Setup menu.
4 – Power Up
When DMX transmit mode is selected, the DMXDart will output the DMX levels
present in last state that DMX transmit was in before it was powered down. A
Power Up fade time can be assigned to give the user an opportunity to either
pause the fade or take the DMXDart offline if the output state going live is not
what is desired.
Use the Ý and Þ or the keypad buttons to set the fade time you want, from 1 to
99 seconds. Press MENU to return to the Setup menu.
NOTE: As a precaution, the minimum power up fade time is limited to 1
second.