Pathway DMX Dart Users Manual - Manual (Page 22)

DMXDart Operation
22
From the Moving Light TX function display, press 2 - SGL / Grp to enter the
setup display:
SGL/GRP setup SGL/GRP setup
Mode Select Mode Select
Mode: group Mode: group
^ ^
Use the Ý and Þarrows to change from Group to Single mode. Press OK. The
display will change to:
SGL/GRP setup SGL/GRP setup
Sgl # within group Sgl # within group
Mode: single: 012 Mode: single: 012
^ ^
Press Ü to move to the fixture number and use the Ý and Þ keys or direct
numeric entry to select the desired fixture number. Press MENU to complete the
selection and return to the Moving Light TX function display.
The top right corner of the display will show whether a single moving light or the
entire group of moving lights is being controlled. If group operation has been
selected, “grp” will be shown. If a single fixture is being controlled, the number of
the fixture will be displayed.
Once the correct moving light has been selected (in this case ML# 78 – HES
Technobeam) attributes can be directly controlled using the Ý and Þ keys,
encoders, or direct digital entry. The joystick is automatically assigned to the pan
and tilt attributes.
To select an attribute, use the Û and Ükeys to move the cursor (^) beneath the
desired attribute. To quickly scroll through pages of attributes, simply press the
NEXT and PREV keys. Once the desired attribute has been selected, values
may be manipulated using the number keys (followed by OK) or Þ and Ý keys.
Regardless of the attribute menu being displayed, the joystick will always operate
the pan and tilt attributes.