Pathway DMX Dart Users Manual - Manual (Page 17)

DMXDart Operation
17
Press Ý to change the format to “Decimal”. Press Ü to move the cursor to the
beginning channel value:
Transmit DMX512 Transmit DMX512
Print Range Select Print Range Select
* Decimal CH:001-050 * Decimal CH:001-050
^ ^
Enter the lowest channel to be printed, in this case 1. Press Ü to move the
cursor to the highest channel value, and enter 400. Press Û twice to move the
cursor below the asterisk (*), position the printer in a direct line with the top panel
of the DMXDart, and press OK. The display will show:
Transmit DMX512 Transmit DMX512
Printing:anykey-stop Printing:anykey-stop
* Decimal CH:001-050 * Decimal CH:001-050
^ ^
To stop the print press any key, otherwise the full range specified, in this case
from channel 1 to 400, will print. To exit the Print DMX display, press MENU or
Û.
Moving Light Control
An advanced feature of the DMXDart is its ability to control a wide variety of
moving lights. The DMXDart contains a complete fixture library of approximately
189 fixtures, and incorporates a joystick and optional encoders for direct access
to moving light attributes.
To enter Moving Light Control (ML-Tx) mode select Main Menu 1 from the Main
Menu Select display. Press 3 - Moving Light TX.
The Moving Light transmit function display will load. During the load something
like this will be displayed:
Moving Light TX Moving Light TX
Technobeam (full) Technobeam (full)
Encoders setup ok! Encoders setup ok!
Note:
If the optional Encoder Wing is not connected, the DMXDart will automatically
disable encoder operation. To enable the Encoders, simply plug the Encoder
Wing cable into the DMXDart and reload the Moving Light TX function.